Finally got my schwinn finished. Afew slow downs along the way. The motor did not fit between the front and seat post well so I attached to front tube and made a mount for the rear. After I had it mounted I found my chain was about 6 inches too short so off to TSC for a 10 ft chain. I had found some slightly used wheels and put new tires on it. The handle bars are Longhorns with a springer. I had to cut the seat tube off because of the rust and just could not get it out. Cut it off and made brackets for front and under springs in the back. Handles a little shacky but fun to ride. During start up it fired right up and only minor carb tuning had it idleing fine. Makes a bit of gear and chain noise but I guess that is normal from what I hear. Was a fun build and kit from boy go fast is acceptable. Next one will probable be a honda 50cc with belt drive or mabey a electric hub drive. http://i185.photobucket.com/albums/x242/coduty3/1-1.jpg
Last edited by a moderator: