urgent! small bevel wheel instalation help please

[linnix13]

i just goy a new small bevel wheel for my zoom bicycles engine kit, how do i instal it? i got the half meen key in facing down then slid the gear on, i then put on the little spacer washer thing(http://www.zoombicycles.com/eShop/6...e/103-bi-bwwasher-Bevel-Wheel-Washer-2-4.html)

and then the slot screw thing, i tightened it up but when i went for a ride the litle moon key shot out, im asuming because the screw loosend, anyways cans omeone walk me through the steps of puting the little bevel wheel back on, every washer and every little nook and cranny, thanks guys! does a washer go behind the small bevel wheel also? thanks and mind my spelling im in a hurry!

 

[linnix13]

ok whatever

i went out and bought this
http://www.shopwiki.com/_Permatex+Cold+Weld+Bonding+Compound

i just slobered it all over the gear and the screw threads, thatl hold!!!!!

 

[MotorBicycleRacing]

Use blue loctite
and more importantly use a hammer impact driver to get the nut tight enough
without screwing up the shallow slot

That small crank gear is one of the weakest links in the 2 stroke motors along
with the clutch freewheel bearing/ setup

 

[linnix13]

Use blue loctite
and more importantly use a hammer impact driver to get the nut tight enough
without screwing up the shallow slot

That small crank gear is one of the weakest links in the 2 stroke motors along
with the clutch freewheel bearing/ setup

i already used that cold weld epoxy stuff, im hoping it will be perminant as if the gear breaks again i will just get a new motor, this one has no compression. do you think the cold weld gel stuff will be strong enough? it says up to 3000psi on the box, also i used a slot screw driver and a hamer and i hamered the little screw tight

 

[linnix13]

verdict

well the verdict's in and............... it works!!!

i was out all day today! i rode all around town and out on the trails. it feels so good to finally get out after sitting for so long. the only problem now is that i will never be able to change the small gear if it breaks. well whatever i got 3000km out of the first gear and i doubt my engine will still be running after another 3000km! i already have bad compression and smoke and a slipping clutch(to much grease?) im definatly happy with my happy time! thanks again guys