centrifgaual clutch

[mackie4]

Hi, I bought a centrifgal clutch for my SD Stinger 80cc motor and I installed the clutch o.k. But the new case is not deep enough to fit against the motor due to the clutch guide pins hitting the case. There is about a 1/4 of an inch gap between the case and the motor. I left the old clutch in so I could pull start the engine. Has anyone had this problem?

mackie4 thanks...

 

[POPS]

Hi Mack

Just grind the clutch pins flush to the plate and you

should be good to go...POPS

 

[Skyliner70cc]

Both my centrifugal clutch installs required me to hacksaw the pins flush. Worked great after that.

 

[mackie4]

Thanks, I guess I will try that....it can not hurt anything. It just does not look like I have enough to take off...on the old clutch...
Thanks again for the response...Mackie4

 

[POPS]

Mack

Go to zoombicycles.com and in the parts go to cent. clutch.

There you will find a link on install inst....POPS

 

[mackie4]

centrifgual clutch

I did greind down the pins and it just clears so I'm good to go...

Thanks Mackie4

 

[mackie4]

Mack

Go to zoombicycles.com and in the parts go to cent. clutch.

There you will find a link on install inst....POPS

Thanks, lot's of info and yes their was a manual on centrifgal clutch install.
Very helpfull, nice site... Mackie4