Tanaka 33 Power Pipes CHEAP!

Status
Not open for further replies.
Here is a picture of what it might look like.

Except this is a 40. Runs like a turpentined Ape. Bought the whole thing from a guy after he put 2000 hours on it.
 

Attachments

  • CIMG3797.JPG
    CIMG3797.JPG
    130.6 KB · Views: 425
Andy', the reason i mentioned "aluminum" is because further down on the item listing it says so, please clarify...and, have you run it yet?

i was gabbin' with ada racing about the 32cc, you & others might find this interesting: http://www.motoredbikes.com/showpost.php?p=262482&postcount=1

Sorry for the late answer.

The pipe is steel, and I have not mounted it up yet. I would like to find an adjustable HP carb first, so I can tune it properly.
 
huh, no luck with that carby yet, eh? you must be going nuts looking at that bling just sitting on the shelf ;)
 
I have been a bit distracted lately. With the weather sucking and other projects, I haven't been too inspired to look around. I'll get to it soon though. It is tough having a cool pipe just sitting there!
 
Hi Sabrewalt,

Do you have any images on the other side? Specifically, how you attached it to the bike for support. I just tried to install my pipe on my bike (with a Tanaka 40cc GEBE kit) and I can't see anywhere that the bracket on the pipe is supposed to attach to the bike to help hold it up. It's awefully close to my rear tire without using the bracket and I'm sure it would not last long just hanging by the two screws where it attaches to the engine.
Any help would be much appreciated.

SS

Except this is a 40. Runs like a turpentined Ape. Bought the whole thing from a guy after he put 2000 hours on it.
 
Tanaka 40 Pipe

No but I will take some more and post them
 
Pictures of my pipe setup

Here are the Pics you asked for Shawn
 

Attachments

  • CIMG4289.JPG
    CIMG4289.JPG
    121.4 KB · Views: 342
  • CIMG4288.JPG
    CIMG4288.JPG
    122 KB · Views: 345
  • CIMG4286.JPG
    CIMG4286.JPG
    120.3 KB · Views: 348
  • CIMG4287.JPG
    CIMG4287.JPG
    125.4 KB · Views: 330
  • CIMG4284.JPG
    CIMG4284.JPG
    123.4 KB · Views: 334
  • CIMG4285.JPG
    CIMG4285.JPG
    116.3 KB · Views: 299
Belt Cover.

No the cover fits fine. I am just lazy. One of these two pictures is a close up of the idle set screw. Shawn. The brass one. Does yours have that?? Can you turn that down. I have a short video of my start.. One pull... That will give you an idea of my idle speed. What is your email address.
 

Attachments

  • CIMG3797.JPG
    CIMG3797.JPG
    130.6 KB · Views: 318
  • CIMG4340.JPG
    CIMG4340.JPG
    122.6 KB · Views: 311
hi sabrewalt, thanks for posting picture, i also bought the performance pack, do you have the performace pck. what is your top speed
thank you
 
Status
Not open for further replies.
Back
Top