??? TIGHTEN THE BOLT ON SHAFT 50cc honda
- Thread starter cycledude
- Start date
Wheres my dog
New Member
Normally when I put clutches on a horizontal shaft engine and I need to tighten the bolt into the shaft.... I normally get someone to pull the pull starter out a few inches and hold it while I crank it down.
Works for me every time! Never lost one yet
K
kerf
Guest
Strap wrench?
cycledude
Member
- Local time
- 2:45 PM
- Joined
- Sep 19, 2009
- Messages
- 72
dog Owner, will try, I noticed the piston sliding when I torqued it and I had a couple of screw drivers through the cooling holes.
I need one of those tools that look like scissors with a couple of cylinder at end but thats not going to work either.
kerf
I tried that but the strap wrench will just hold the bell, the rotor keeps turning.
Ill show you what I had to do to get the clutch mounted on there later, a real b%&^h
I need one of those tools that look like scissors with a couple of cylinder at end but thats not going to work either.
kerf
I tried that but the strap wrench will just hold the bell, the rotor keeps turning.
Ill show you what I had to do to get the clutch mounted on there later, a real b%&^h
K
kerf
Guest
Can you see the piston through the plug hole? If so, a piston stop will work, try a lawn mower shop.
SimpleSimon
Active Member
Yep.
Made my own with an old spark plug and a chunk of hardwood dowel rod gel type superglued up into the electrode hole (which I broke out of the plug). Made it long enough that the piston is held well down in its stroke, and the hardwood won't mar the aluminum piston.
cycledude
Member
- Local time
- 2:45 PM
- Joined
- Sep 19, 2009
- Messages
- 72
Well I saw another clutch thread up in the GD section so that's where I slamed this one, who knew?
Anyway thats how it looks, I had to make a spacer bcause the shaft is too short I hope it holds when I give it the works.
the last one is how it looks without the bell, is a little more than 1/4".
Im thinking that the force is on the bell only when the rotor is open so.
Anyway thats how it looks, I had to make a spacer bcause the shaft is too short I hope it holds when I give it the works.
the last one is how it looks without the bell, is a little more than 1/4".
Im thinking that the force is on the bell only when the rotor is open so.
Attachments
cycledude
Member
- Local time
- 2:45 PM
- Joined
- Sep 19, 2009
- Messages
- 72
the idea is to make something like the one selling for 7500? but with a 50cc.
im going to slam it on the bmx and get some more health insur
lol
I forget that I also had to grind a little of the back of the rotor, there is a massive chunk of metal there.
and I could have made the spacer by cutting a piece of 5/8" shaft and drill a hole but I had this one made since I dont know how much shaft I'm going to need
im going to slam it on the bmx and get some more health insur
lol
I forget that I also had to grind a little of the back of the rotor, there is a massive chunk of metal there.
and I could have made the spacer by cutting a piece of 5/8" shaft and drill a hole but I had this one made since I dont know how much shaft I'm going to need
Last edited:
Similar threads
