Fletch
Member
I have a noisy (rattling) HT, so I pulled off the head and cylinder body...took off the cylinder to look at the pin, and the roller bearing . Both of them look OK.
From what I can tell, the play in the cylinder is from the roller bearing being not as wide as the gap in the cylinder?
There is about 3-5 mm side to side play in the connecting rod. This is annoying, but I'm not sure if it'd of any significance or not? Is it worth tearing the engine open?
From what I can tell, the play in the cylinder is from the roller bearing being not as wide as the gap in the cylinder?
There is about 3-5 mm side to side play in the connecting rod. This is annoying, but I'm not sure if it'd of any significance or not? Is it worth tearing the engine open?