kinda like Frankenstein haha.
so back in march or april my needle bearing inside the piston collapsed into its self and broke apart inside the engine...it resulted in horrible damage to the piston housing and pretty much the engine seized up. so that engine is sitting on the side lines and being used as a salvage engine.
I bought a bottom half of an engine off of a site and a buddy of mine gave me a top half of a spare engine he had lying around. so i put the 2 together. everything fit in perfectly
my main question is i wanted to test it to see if it would actually work...i tried checking for a spark by walking with the bike but the back tire just freezes up// what would cause this?
also i dont know if its relevant but i did adjust the clutch plate. i did notice my clutch handle is a tad bit harder to work. maybe too tight?
i'm a paranoid person so...
my worry is are these 2 parts not compatible??
or since theres no gas or oil maybe it needs it in order to move the piston? any help or advice would be greatly appreciated.
so back in march or april my needle bearing inside the piston collapsed into its self and broke apart inside the engine...it resulted in horrible damage to the piston housing and pretty much the engine seized up. so that engine is sitting on the side lines and being used as a salvage engine.
I bought a bottom half of an engine off of a site and a buddy of mine gave me a top half of a spare engine he had lying around. so i put the 2 together. everything fit in perfectly
my main question is i wanted to test it to see if it would actually work...i tried checking for a spark by walking with the bike but the back tire just freezes up// what would cause this?
also i dont know if its relevant but i did adjust the clutch plate. i did notice my clutch handle is a tad bit harder to work. maybe too tight?
i'm a paranoid person so...
my worry is are these 2 parts not compatible??
or since theres no gas or oil maybe it needs it in order to move the piston? any help or advice would be greatly appreciated.