Centrifugal Help ? Before I take centrifugal clutch apart.

Well motor the sleeve the goes over the shaft is taper then the gear locks into the sleeve with bolt.You have to make a key slot in the sleeve for a key or go with out it.I have read people going with out the key and never having problems.
 
Well motor the sleeve the goes over the shaft is taper then the gear locks into the sleeve with bolt.You have to make a key slot in the sleeve for a key or go with out it.I have read people going with out the key and never having problems.
Are you saying... that there is a sleeve (included with kit) that goes over the crankshaft, and it is tapered on the outside, and the clutch slides over the sleeve? I still can't figure out why they didn't have a slot for a key. In post #6, what is included in the plastic bag? You can drill a hole in the sleeve, tap it and insert a allen screw through to the keyway cutaway, if you have problems.
 
Last edited:
Okay Al the sleeve is tapered on the crank shaft side,and u cut the key out on the sleeve because it doesn't have a slot.The sleeve comes out with a bolt hole at the end the gear and clutch bell slides over the sleeve and bolts down in the crank.There is a kinda lock on the sleeve the locks the gear too the sleeve.
 
I have a 48cc engine with a centrifugal clutch and today as I got in the driveway it went bad no pull from motor at all, still running Idles great.So I shut it down.I went to roll it in garage and it rolls with a little drag but not much with clutch lever out,or in.So were should I tear a part first.I want to see who can get my problem answer first.I'm kinda bummed,but lets have some fun guessing the problem. Thanks A bunch!

I'm confused. Is your bike manual clutch or centrifugal clutch?
 
I'm confused. Is your bike manual clutch or centrifugal clutch?

If they work like I think they work (see kit post #6) Remove the OEM cover plate and small gear. The manual clutch is installed on the clutch shaft, and is always engaged, install the the adapter plate supplied in kit. Install the CC, gear in CC turns large clutch gear, install the supplied cover plate.
 
Last edited:
Yes al it all fits on the small gear shaft or crank shaft and the regular clutch stay the same place.
 
Back
Top