zippinaround
Active Member
just trying to remove a bearing cup from the hub, i managed to get the undamaged one out easy enough but the damaged one just will not budge!
Last edited:
There's the problem, I looked into the same thing a while back, the way the industry is they expect the end user to buy a new hub or whole new wheel.There are NO real suppliers, not in the sense that you can buy everything else down to loose bearings.My plan was to pull the cups from an old hub and use those, but that doesn't mean they'll fit, there is no standard for cups outer diameter.I found one supplier in India, but if I remember correctly you'd have to buy a lot of cups.If we could get a group of buyers here I'd be willing to put a few bucks in for 6 or so cups for the future.New hub, pull some cups from a hub, or check with your LBS, they may have some loose.i just want to replace the bearing cups or if i can just throw in cartridge bearings? the rest of the rim and spokes are fine.
It's not that you CAN'T get them, it's that you probably have to buy 50,000 units.You need not replace the hub, cups can be pulled and reseated, find a hub on ebay of the same make as your hub, pull the cups and press/hammer them into your wheel, there's posts on "bike forums" detailing this process.sorry no cups period available.non replacable.
cones and axles and loose bearings fine / but no cups period. full replacementis needed for the hub no question.
Not true, where there's a will,...Here's a quote from Sheldon Brown, "Examine the cups (in the hub shell) in the same way. In most cases it is not possible to replace the cups without replacing the whole hub, but fortunately the cups usually are the last parts to wear out. If the hub is cleaned regularly, lubricated and kept in good adjustment, the cups should last indefinitely."
Looks like your SOL on the hub cups.
Chris
AKA: BigBlue