At last! She's finally alive

[Neufcruz]

Put some fuel in and fired up on 1st drop if clutch. Now she seems to bog a little about halfway through throttle when riding but not when. Sitting and free reving. After bog if you pin it, it then slowly then builds up.Also, had to adjust clutch multiple times, going tore place cable tonight as well as it is little frayed. Seems to be squeaking noise coming from there when riding. Cones and goes as you pull in clutch etc...
What's next? Pull plug?
Thanks to all!
Mike

 

[Neufcruz]

Any ideas of what would cause that squeeking is from clutch?

 

[Neufcruz]

Took left side drive gear cover off and noticed the clutch push bar was dry. Packed full of grease and squeeking is gone.

 

[sbest]

Beautiful bike. Nice work on the pipe. How does it work?

Steve

 

[Neufcruz]

Beautiful bike. Nice work on the pipe. How does it work?

Steve

Had to wrap it up just in case I get lazy and forget it's there. I'm sure it would remind me. Lol
Not sure how it works as I have nothing to compare it too. It does sound nice and raspy. Like my old cr250. A bit louder entrap I want but not changing pipes again. Attest not yet.

 

[wheelbender6]

The bog might be solved by setting the needle in the carb a bit higher.

 

[Neufcruz]

Had to wrap it up just in case I get lazy and forget it's there. I'm sure it would remind me. Lol
Not sure how it works as I have nothing to compare it too. It does sound nice and raspy. Like my old cr250. A bit louder entrap I want but not changing pipes again. Attest not yet.

I don't have the stock nt carb. It's a dellorto clone so only a main jet to change

The bog might be solved by setting the needle in the carb a bit higher.

I don't have a stock nt carb.its a dellorto clone so only main jet to change. I rejected since and big is gone. Stll room for improvement but will wait till fully broken in and right oil ratio is in to fine tune. By then it will be in the 90s here so that will affect as well.
Mike