Bought a bike have some questions about adjustments

[HeadSmess]

the seat CLAMP is one-size fits all, (except for them "micro-tilt" fancy types), the seat POST is not!


may have been a typo for 25:1 as well, which aint tooo bad for the oil.

lots of things make the engine struggle.... more specifics, please?

 

[Neufcruz]

Was the clutch issue fixed? Can't imagine 5.1.

 

[butre]

the seat CLAMP is one-size fits all, (except for them "micro-tilt" fancy types), the seat POST is not!


may have been a typo for 25:1 as well, which aint tooo bad for the oil.

lots of things make the engine struggle.... more specifics, please?

not quite one-size fits all, I had to bend out a clamp from an old BMX bike to fit the mountain bike post in my skyhawk frame

 

[Holly]

sorry, that's wrong info for clutch adjust - first adjust cable for almost no slack, then lock lever and adjust flower nut until motor trys to turn when rolling bike, now back off the flower nut till motor no longer tries to turn when rolling bike, lock flower nut and release lever and readjust cable if needed

My flower nut doesn't move at all. And yes I've removed the screw. Any ideas?

 

[2wheelfantasie]

pull the clutch in then try and remove the nute. Check out my channel https://www.youtube.com/channel/UCO17lH0_XM1EtcDyXn9Yofw

 

[Holly]

pull the clutch in then try and remove the nute. Check out my channel https://www.youtube.com/channel/UCO17lH0_XM1EtcDyXn9Yofw

Thanks! I'll give it a go!

 

[2wheelfantasie]

if that doesnt work make sure you have the clutch in get a scew driver and a hammer and smack it counter clock ways, then it should work

 

[Holly]

if that doesnt work make sure you have the clutch in get a scew driver and a hammer and smack it counter clock ways, then it should work

The clutch arm?

 

[2wheelfantasie351]

The clutch arm?

Yeah make sure that in so the bike can roller. If you have the stock clutch lever just make sure the pin is in. Then on the clutch side apply pressure to back of the clutch and try And spin the flower nute

 

[Holly]

Yeah make sure that in so the bike can roller. If you have the stock clutch lever just make sure the pin is in. Then on the clutch side apply pressure to back of the clutch and try And spin the flower nute

Unfortunately it won't budge still.