Carby carb stock on full throttle

Local time
5:05 AM
Joined
Apr 1, 2016
Messages
392
Location
near west side Chicago
I've done everything I possibly could the Barrel is going up and down perfectly the pin is set at the top notch because it was too rich the throttle cable is working fine . Throttle

Help!!! Help! Help!! Help! I need help please help me!!!!!!
I'm totally at a loss on what to do? The only thing I have not messed with is the float and I have a feeling that's not it I have tapped. Bbit with a wrench to loosen it up and it's swelling up and down I'm sure
 
air leak, or slide in upside down, or left out the washer that holds the needle down in the slide
 
Ok, I have the solution. Take off the cap where the throttle hooks up to the carb, take it all apart and put it back together, it happened to me. Pay close attention on how you put it together. That should fix it
 
The barrel could be rotating and getting stuck on the idle screw due to a slightly bent spring, this is what happend to mine and it is NOT fun when the bike suddenly runs away and your brakes are utter s**t
 
With all due respect I did that, The barrel lined up, It moves up and down is really nice that it goes in the hole I had to reposition the whole to the top 10 because I just running way to Rich I was running so rich I was getting fuel oil mix inside my air filter

Thank you, be safe, and have fun.
WINDY CITY BOB
P.S. The only thing I have NOY checked is the float inside the bowl
 
note: fuel blowing back into filter is normal for a motor without reed valves
 
I havemt seen too much on reed valves them I don't know much about them where they're located what they do I have seen a couple videos but I really don't know what they are what they do I'm going to have to go to YouTube University I think
 
Back
Top