I had to gently pry on the plates here to stretch the rubber gaskets enough to allow the plates to not overlap.
I had to gently pry on the plates here to stretch the rubber gaskets enough to allow the plates to not overlap.
I started with each Center Bolt on each Plate, then the 1st Bolt in each Plate, then the 3rd Bolt in each Plate, working my way around, gradually tigh
Completed installation of new Sprocket onto Rear Wheel.
Next is to mount the Rear Wheel back on the Bicycle.
Rear Wheel mounted. Put the Rear Fender back on.
Slide Push Rod into Rear Axle and tighten Shimano Bell Shifter onto Axle. Put Bicycle in 2nd Gear and adjust nut on cable to put yellow dot centered
Instead of drilling more holes in the frame of the Cargo-T, I went with making an adapter plate to mount the Front and using the supplied plate to mou
D

I had to gently pry on the plates here to stretch the rubber gaskets enough to allow the plates to not overlap.

There are no comments to display.

Media information

Album
Torker Cargo -T Flying Horse 2-Cycle Installation
Added by
dinoseer
Date added
View count
338
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top