add a 90 degree grease( Gear Box Cover)

Discussion in '2-Stroke Engines' started by MRJOHN, Jan 28, 2010.


    MRJOHN New Member

    add a 90 degree 1/4 grease fitting to your Gear Box Cover

    Attached Files:


    MRJOHN New Member

    you may need to add a washer:idea:

    Attached Files:

  3. Al.Fisherman

    Al.Fisherman Active Member

    That was going to be my next mod, plus one in the engine valley for the clutch shaft (where the post for the clutch cable WAS)
  4. Rob_E_Rob

    Rob_E_Rob Member

    Is this a good idea? Won't that saturate the clutch eventually?

    MRJOHN New Member

    i have pics so you can see inside or by the clutch ,all you have to do is add a Washer or two

    Attached Files:

  6. mountain80

    mountain80 Member

    Heck of a good idea, I have an machined adapter somewhat like this for my output shaft/bearings that simply screws into the cluch cable post thread for greasing then is removed till next time. If one was to add a MODERATE amount of grease while the engine is at idle I'm thinkin it would do a good job, could always shut down the engine and pull the cover and see the grease distribution as well getting an idea of how much of a portion of a stroke of a grease gun one needs.
  7. Dilly Bar Rob

    Dilly Bar Rob Member

    Great idea!

    Will be my next mod.

    Yeah I guess a guy would have to watch out not to over do it with the grease, just one quick pump with the gun should do.

    Mind you, you still have to take the cover off occasionally to grease/lube the "ball race", so you get to see if your putting too much grease in there.
  8. Huntington

    Huntington Member

    very nice mod, I will be stealing this one too.