Carby Air Intake repair/swap

mobydick

New Member
Local time
5:46 PM
Joined
Jul 15, 2013
Messages
1
Location
bham
Howdy...so my stock air intake split down the middle and needed replacement. I went with one I found on gasbike but there was no sort of sizing information, or any information at all for that matter. SO when it arrived and I went to put it on it doesnt quiitte fit, a hair to large on the screw holes. also curious about the intake hole on the new one vs the stock as they are different. I have a HT 66/80 and the stock port is elongated where as the new pipe is just a plain ole' circle, will this make a difference IF i am able to fit it? or should i order a new pipe somewhere?

I beleive I ordered a gt5 intake but i see they also offer a gta5? is there a way to find out what i need?


MotoBike.jpg
 
a small round file, such as used for sharpening chainsaws, should fix all issues ;)
 
Where did you order your kit from? It looks similar to my PK80. And what about the intake? I ordered a Z offset intake from JNMotors and I too had to dremel out the holes a little bit.
 
Back
Top