At last! She's finally alive

Discussion in 'General Questions' started by Neufcruz, Mar 7, 2016.

  1. Neufcruz

    Neufcruz Member

    image.jpg image.jpg image.jpg image.jpg image.jpg Put some fuel in and fired up on 1st drop if clutch. Now she seems to bog a little about halfway through throttle when riding but not when. Sitting and free reving. After bog if you pin it, it then slowly then builds up.Also, had to adjust clutch multiple times, going tore place cable tonight as well as it is little frayed. Seems to be squeaking noise coming from there when riding. Cones and goes as you pull in clutch etc...
    What's next? Pull plug?
    Thanks to all!

  2. Neufcruz

    Neufcruz Member

    Any ideas of what would cause that squeeking is from clutch?
  3. Neufcruz

    Neufcruz Member

    Took left side drive gear cover off and noticed the clutch push bar was dry. Packed full of grease and squeeking is gone.
  4. sbest

    sbest Active Member

    Beautiful bike. Nice work on the pipe. How does it work?

  5. Neufcruz

    Neufcruz Member

    Had to wrap it up just in case I get lazy and forget it's there. I'm sure it would remind me. Lol
    Not sure how it works as I have nothing to compare it too. It does sound nice and raspy. Like my old cr250. A bit louder entrap I want but not changing pipes again. Attest not yet.
  6. wheelbender6

    wheelbender6 Well-Known Member

    The bog might be solved by setting the needle in the carb a bit higher.
  7. Neufcruz

    Neufcruz Member

    I don't have the stock nt carb. It's a dellorto clone so only a main jet to change
    I don't have a stock nt carb.its a dellorto clone so only main jet to change. I rejected since and big is gone. Stll room for improvement but will wait till fully broken in and right oil ratio is in to fine tune. By then it will be in the 90s here so that will affect as well.