[Clutch] How do I install a brake/clutch lever combo?

Discussion in 'Transmission / Drivetrain' started by rjriggs, Aug 28, 2015.

  1. rjriggs

    rjriggs Member

    I have a Dax kit that I'm almost done installing. I'm stuck on installing the brake/clutch lever combo. I've attached a picture.
    0828151434a.jpg
    As pictured, the brake cable is going into the upper barrel. I assume put a barrel on the lower hole and run the clutch cable to it...but where does it attach to?
     

  2. crassius

    crassius Well-Known Member

    that's your clutch lever (extra hole is for brake light button if used for brakes

    most folks hook clutch to it & set it to hang down a bit, the hook rear brake to another lever set a bit higher (you'll only pull one at a time)
     
Loading...