clutch wont disengage?

newuser

New Member
Local time
2:44 AM
Joined
Sep 1, 2015
Messages
3
Hello everyone so the problem i have is when i pull in the clutch lever the back wheel wont disengage I was told to pull out some slack then give the bike a good push to give but still no luck does anyone have a solution? thanks in advance
 
many new motors have the clutch stuck from sitting on shelf too long - usually one can lift back wheel while holding clutch lever and kick the pedal down to free it

if not, then open the clutch cover and hold lever while tapping a bit on clutch, that should free it
 
If your new to clutch / cables, the angle of the cable, as it enters the stop post is a consideration. Too steep an angle, and the cable binds. When adjusting clutch cable, screw in tensioners, they loosen, not tighten when the cable breaks in. Pull all slack out, and tighten stop. Once adjusted, put a dollop of epoxy glue next to the cable stop bolt. I use a Brake Caliper Pinch Bolt behind the stock [ Brass ] Cable Stop, than cable is cut, and a dollop of epoxy applied to exposed ends
 
Back
Top