Cramming a stock peanut tank into cruiser frame

Discussion in 'Painting, Welding, Bending and Gas Tanks' started by Fast Shag, Dec 16, 2015.

  1. Fast Shag

    Fast Shag Member

    It holds fuel, has good flow to carb, and gives it a sporty look.....I bent down the front lip, retapped a petcock on bottom front, bent studs so it would fit around double tubes. You might want to cut them off so you don't risk cracking tank. This tank was already cracked, I used fuel proof glue by locktite, and covered that with jb weld. It's been holding fuel for 3 days now. I don't fill it completely up, but when riding, it doesn't leak at cap. It still holds a good amount of fuel. Keep in mind that not all beach cruiser frames are the same. PC110469.JPG PC110467.JPG
     

  2. butre

    butre Well-Known Member

    looks a whole lot better than sticking it up top.
     
    Fast Shag likes this.
Loading...