How I sealed the wiring hole in a 66cc engine

Discussion in 'Electrical' started by mikedabomb, Jan 29, 2016.

  1. mikedabomb

    mikedabomb Member

    Acquired 10 tubes of assorted sealants, some used and with the tips gummed up. The first one to not be already set in the tube was this stuff called siliconized acrylic latex sealant by Sherwin Williams. It says that it seals for 60 years, lol. Here's photos of the sealant bottle and the job I did around the hole

    (would advise against using your bare finger for this stuff, comes off with a wash though)

    It felt extremely sticky/tacky. Hopefully this does the trick. I expect my motor bike to go through a lot when it's ready, so hopefully this stuff holds up. I will edit this post in a week to add a field review once it's been used and put to the test.

    Thanks for reading, share your thoughts!