I used this drawing to build 3 perfect working FDs.

Discussion in 'Friction Drive' started by Mercurius, Jun 27, 2012.

  1. Mercurius

    Mercurius Member

    A Harbor Freight mini mill was used to drill and mill the 4" aluminum channel. Hope this helps anyone out there.


    FD2.jpg FD3.jpg FD4.jpg
     

  2. happycheapskate

    happycheapskate Active Member

    What else did you use? (staton parts?)
     
  3. loquin

    loquin Active Member

    I'm curious as to why you crossed out the 71mm spacing on the drawing, and changed it to 70, since it should be 70.7mm (and therefore closer to 71 than 70.)
     
Loading...