Engine Trouble Led ball from throttle cable went through engine

Discussion in '2-Stroke Engines' started by prairie breeze, Jul 20, 2011.

  1. prairie breeze

    prairie breeze New Member

    help please i built a chopper with a 80 cc it ran fine until the little led ball came off the end of the throttle cable and got sucked through the engine i just replaced the top end. piston & jug now i cant get the engine to start i have tried all the things i have read here but nothing seams to be working any ideas?
     

  2. HeadSmess

    HeadSmess Well-Known Member

    ive never had troubles with lead going through the engine...brass does a bit of damage, but not lead.

    if you was worried about lead damaging the cylinder and piston, what about crank bearings and conrod bearings? at which point youd have replaced the engine...

    usual stuff.

    spark. check it.

    take carb off, pour some fuel down the manifold and try and start it.

    did you put new rings on the piston?

    how about bottom cylinder gasket? round the right way? or the cylinder, even?

    maybe the leads stuck in ya spark plug!

    iunno.
     
  3. prairie breeze

    prairie breeze New Member

    photos of the damage

    here is what i found when i pulled the engine apart . I replaced the cylinder and piston with all new gaskets only thing not new is the plug will try that tomorrow.
     

    Attached Files:

Loading...