T thinkgreencycles New Member Local time 5:09 AM Joined Mar 20, 2010 Messages 3 Mar 20, 2010 #1 how do you check a magneto?
wheelbender6 Well-Known Member Local time 6:09 AM Joined Nov 13, 2008 Messages 2,800 Location TX Mar 20, 2010 #2 Welcome to the forum. I'm guessing you could hook a volt meter to your blue wire and spin the motor. I've never tried it.
Welcome to the forum. I'm guessing you could hook a volt meter to your blue wire and spin the motor. I've never tried it.
AussieSteve Active Member Local time 9:09 PM Joined Oct 28, 2009 Messages 1,733 Location Nowra, NSW, Australia Mar 21, 2010 #3 With a DMM, measure between blue and black, (ground). Expect about 330 ohms. Do this test with the CDI unit disconnected. Between white and ground, expect about 2-3 ohms. If it measures less, disconnect the kill-switch and try again.
With a DMM, measure between blue and black, (ground). Expect about 330 ohms. Do this test with the CDI unit disconnected. Between white and ground, expect about 2-3 ohms. If it measures less, disconnect the kill-switch and try again.
T thinkgreencycles New Member Local time 5:09 AM Joined Mar 20, 2010 Messages 3 Mar 22, 2010 #4 Thanks for the info. Also does the 48cc-66cc etc.use the same magneto? thanks JIM
AussieSteve Active Member Local time 9:09 PM Joined Oct 28, 2009 Messages 1,733 Location Nowra, NSW, Australia Mar 22, 2010 #5 Yep.
T thinkgreencycles New Member Local time 5:09 AM Joined Mar 20, 2010 Messages 3 Mar 22, 2010 #6 thanks Steave