New Motor Mounts

Discussion in '2-Stroke Engines' started by Timbone, Mar 10, 2016.

  1. Timbone

    Timbone Active Member

    I took the time this evening to build a new front motor mount for my new HT engine. Here's a pic: mount1.jpg

    These are two heavy L brackets (4" wide) that I found in the Lowe's building material area. Very cheap but thick, strong metal. I trimmed the overlapping edge a bit and they are connected by 4 big nuts and bolts (1/2") that I will permanently fix with red locktite. That's a 1 1/2" muffler clamp that will grab the downtube. I'll probably attach the motor to the backplate with at least a 5/16" grade 8 bolt combo.
     

  2. skyash

    skyash Active Member

    Where was that when I needed it for my diy shift kit. Not bad.
     
  3. mrbg

    mrbg Member

    Those look like teco plates, for wood framing.it looks kinda like the mount they sell on SBP, with the muffler clamp.
     
    Timbone likes this.
Loading...