Clutch problems

john morrow

Member
Local time
1:55 AM
Joined
Aug 23, 2016
Messages
54
Location
Pensacola Florida
I need help fixing my clutch. The little bar that pushes in when you clutch is stuck took the cover of where the small sprocket is and that little bar that goes in to the hole of the small sprocket is all the way in you can pull it out and that's about it. How can I fix this problem?
 
There is meant to be one or two ball bearings in there too depending on your engine , usually that's the problem
 
well the bar should stick out about 12mm i think so you will know just go get some goodish balls you will see if its one or 2
 
I doubt 2 balls will work properly without jamming - one 8mm (or 5/16in) ball is used - be sure there isn't already one in there before putting another in.
 
I get them at a local h/w store that specializes in metric stuff, but 5/16 is only about 2/1000in smaller and will work OK
 
Back
Top