Re-install Engine Drive Sprocket

[nemesiszero]

Hey simple one here just removed the engine drive sprocket from 80cc just to inspect it. I used the black removal tool to take it off and just want to make sure putting back on right. So I am thinking as it pulls off I assume it pushes back on so do just need to keep tightening the silver lock nut as the clutch pin now does not stick out far enough to touch the clutch arm.

Thanks again guys...

 

[crassius]

should just go on OK by tightening the nut if key is lined up

did you lose the ball bearing behind the bucking bar?

 

[nemesiszero]

should just go on OK by tightening the nut if key is lined up

did you lose the ball bearing behind the bucking bar?

Don't think so as I never took the bar out

 

[Fabian]

did you lose the ball bearing behind the bucking bar?

I agree.