So it's time to get some new clutch pads but I was wondering could I just make me own?
I'm sure someone has tried this before.
Also As for the Clutch plate and the locking screw.
Should the plates be sanded to be more rough to catch better and do those small square notches in the plate mater too much? I have been sanding it every so often and I know at some point they will be worn flat.
As for the locking screws where can I get a new one or what size is it. so far I have used the screws from old v-brake adjustment screws and dremel cutting them to size.
I'm sure someone has tried this before.
Also As for the Clutch plate and the locking screw.
Should the plates be sanded to be more rough to catch better and do those small square notches in the plate mater too much? I have been sanding it every so often and I know at some point they will be worn flat.
As for the locking screws where can I get a new one or what size is it. so far I have used the screws from old v-brake adjustment screws and dremel cutting them to size.