Throttle cable hook up

Discussion in 'General Questions' started by s_beaudry, Aug 21, 2008.

  1. s_beaudry

    s_beaudry Member

    I did a search thru the forums here and could not find a explaination of how to...

    So, what is the correct way of hooking up the throttle cable to the carb? Just want to be sure I am doing it correctly!

  2. rjwenzel

    rjwenzel New Member


    What kind/brand of motor do you have? On my Power King, the directions told me to do it this way (see pictures).
  3. rjwenzel

    rjwenzel New Member

    Sorry . . .

    Sorry, my previous reply shows pictures of the Clutch assembly. I don't have pictures of the throttle.
  4. s_beaudry

    s_beaudry Member

    The engine is a 66cc...

    How do you attach the throttle cable into that fitting ontop of the carb? What does the cable connect to inside the carb?
  5. dwsutton

    dwsutton Member

    You have to take out the sleeve that is inside the carb - if you look on the side of the carb and push up on the sleeve it will come out the top of the carb and you can then see the indentation where the cable end goes in the side of the sleeve - make sure to put the top section over the cable before slipping it into the sleeve - then slide the sleeve with the cable installed back down into the carb and tighten the top back down :)

  6. coolshoeshine

    coolshoeshine Member

    God Bless You Man!!

    I was trying to figure this out because my instructions SUCK!! hahaha