took my engine apart to address clutch prob [ diagram ]

Discussion in 'Frame Mounted Engines' started by irish13, Jul 24, 2007.

  1. irish13

    irish13 Guest

    so i took it apart to address a clutch problem only to realize that when i went to put it back together i had a spring that i dont know what side of the clutch plate it goes. it is the spring that is about the diameter of a quarter and about an inch tall, what side of the clutch plate does it go?
    any help?
    irish
     

  2. azbill

    azbill Active Member

    does this help ?
    [​IMG]
     
  3. irish13

    irish13 Guest

    so it goes between the plate and the pads?
     
  4. grakker

    grakker Guest

  5. fairracing31

    fairracing31 Guest

    Hey azkronic, where did you get that from? I would love a manuel with all specs for these things. I've been doing it blind and so far I've been lucky not to screw anything up.
     
  6. azbill

    azbill Active Member

  7. also on the grubee site...
     
  8. davidsis

    davidsis Guest

  9. wanderer33

    wanderer33 New Member

    clutch racer

    Hi azbill.
    You've responded to some of my threads before for which I thank you
    and hope you can tell me now what to do.
    I have seen on other posts comments about clutch racer and suggestion about adding ball bearings,as I thing this is my problem as I can see a gap
    between the balls but couldn't work out how to take it apart.
    I red that it is pressed together but I'd appreciate if you let me know how to
    separate it and put it together.With Thanks. V.





     
Loading...