Torque of intake/exhaust studs.

Discussion in '2-Stroke Engines' started by Waxxumus, Dec 28, 2015.

  1. Waxxumus

    Waxxumus Member

    Does anyone here know what the proper torque of the intake and exhaust studs are? Im in the process of replacing them. Id rather use a torque wrench to tighten them down just to be on the safe side.
     

  2. crassius

    crassius Well-Known Member

    6 to 8 ft/lbs should be enough - remember that if muffler hangs a bit off center, to add a hanger strap to the bottom to keep it from rotating enough to pull the studs out
     
  3. butre

    butre Well-Known Member

    depends mostly on how flat your exhaust flange is. 8 ft lbs and double nutted is what I do.
     
Loading...