jimraysr
Member
I have two GruBee gear boxes. Bought them from two dealers on each end of the country.
The clutch key way is (4.35mm) wrong in both.
The bell housing bushing has about the same slot (4.6mm) as the Honda GXH50 (4.7mm).
Key supplied, 4.55mm
Has anyone else had this problem? and if so how did you solve it?
As the bell bushing uses the same key as the clutch, it would be best if they had the same slot.
Suggestions appreciated.
Jim
The clutch key way is (4.35mm) wrong in both.
The bell housing bushing has about the same slot (4.6mm) as the Honda GXH50 (4.7mm).
Key supplied, 4.55mm
Has anyone else had this problem? and if so how did you solve it?
As the bell bushing uses the same key as the clutch, it would be best if they had the same slot.
Suggestions appreciated.
Jim