Mikuni Carburetors (mad video)

arielatom300heps

New Member
Local time
11:30 PM
Joined
Jun 14, 2008
Messages
27
Location
South Australia
Has anyone seen this video (http://www.youtube.com/watch?v=onioqw0w38Y) before?

Does any one no this person(s) who are in the video as I would like to find out some information of exactly what mods have been done to get this performance.

It says he has a mikuni carby on it but which one. I went on show and go Motorcycles web site (http://www.showandgo.com.au/mikuni/mikuni.htm?mikuni_bf.htm~mainFrame)
and they are so many different ones. Which one does the guy in the video run?

I am in the process of putting a tuned pipe on my bike. I have ridden my mates bikes who have tuned pipe on there bike and have notice that both there bike are staved of fuel (mainly on the top end)and I think more power could be extracted from extra fuel flow. So I wanted to put a better carby on my bike when the tuned pipe is installed.

Also what gearing do you think this guy is running?

Mark
 
I sent him a message. I have put a 18mm mikuni on my bike, along with a pocketbike chamber, and am trying to get the jetting right... I will keep you posted.......

Is your 18mm mikuni carby the round sided or flat sided?

Do u think a bigger 20mm or smaller 16mm is needed or is 18mm the right one for the job?
 
Does this guy have a user name on this forum?

I did not see a name on the video site there was a link to send him a message and I did.....

misteright1_99

Is your engine a 49cc or 66cc?

I have a 48cc.....

Is your 18mm mikuni carby the round sided or flat sided?

Do u think a bigger 20mm or smaller 16mm is needed or is 18mm the right one for the job?


I have a 18mm Mikuni round slide. I believe 18mm is the max. A 16mm might be less tuning as I had to change pilot jets and mains....
 
does Mikuni BV-18 18mm will be ok for the bike ?

http://cgi.ebay.ca/E-Z-GO-1982-87-2...VQQcmdZViewItemQQ_trksidZp1638Q2em118Q2el1247


I hit 35 mph flat road with my 27 sprocket so if i can have more speed i will have to change the HT for having more fun.

Im sorry I am not familiar with that carb, must be new. It doesnt look like any Mikuni I have ever seen. I got mine off ebay, listed as carb for 1970's 80cc Yamaha dirt bike, I think it was a GT80. It has the same type of clamp that the stock carby has so I did not have to modify the carb or manifold....

This looks like the carb I purchased..................Note the mounting flange.........
http://cgi.ebay.com/ebaymotors/1970...005QQitemZ150271173923QQrdZ1QQsspagenameZWDVW
 
Last edited:
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.
Back
Top