Engine Level How Important ???

Don't get carried away though by all this sophistication and imagine that anything goes,I remember reading a thread in which someone had mounted a brandnew Subaru engine permanently at an angle and ran into lubrication problems.I don't recall the exact circumstances, but it was toast, a real bummer.
 
that thing will take a lot of tilt -- no oil in crank case

have a happy time on your Happy Time

as we all ride those motor bike things

on my last engine when changing the barrel/cylinder i got some oil in therte by mistake when oiling the piston and the rings to help it slide into position. Afterwards it ran like a beast ^_^

might try that again see how we go :)
 
maybe just a good one -- ran like a beast

on my last engine when changing the barrel/cylinder i got some oil in therte by mistake when oiling the piston and the rings to help it slide into position. Afterwards it ran like a beast ^_^
might try that again see how we go :)

yes always a good idea to put (( a little )) (( oil )) on any piston rings
we happen to get close to
such as after a rebuild
or we just happenen to be in there scraping off carbon or someTHING ??

dry brand new rings, jug ect can use some lube to hold them over
until THINGS get spinning good in that 2-stroke gas
or with the 4-stroke -- oil either pumped up from the crank case
or thrown up so as to lube engine with the little spoon dipper

ride that THING
 
yes always a good idea to put (( a little )) (( oil )) on any piston rings
we happen to get close to
such as after a rebuild
or we just happenen to be in there scraping off carbon or someTHING ??

dry brand new rings, jug ect can use some lube to hold them over
until THINGS get spinning good in that 2-stroke gas
or with the 4-stroke -- oil either pumped up from the crank case
or thrown up so as to lube engine with the little spoon dipper

ride that THING



i replaced the piston/cylinder barrel as i stuffed the exhaust mount :( So i put some lubricant ( 2 stroke) over the piston and the rings and within the cylinder ( new one) so it'll fit nice and smooth and i got some in the case underneath the piston when i was holding it up. :giggle:
 
Back
Top