brendonv
Member
Well i havent been on here in a while, been busy with the homework of 5 TEE subjects. Anyway i built a friction bike yonks ago, some may remember. Well it was very crappy, it worked fine but it had major flaws. It was non adjustable, weak and just didnt look good, sooooo i scrapped that and made another one. Im a bit more knowledgeable now with metal work and motorized bikes so i made a very nice, strong, easy design that just works great. It is adjustable by a brake lever so i can raise and lower it, it will work sort of like an centrifugal clutch. This way, when i stop at lights and such i can just pull the lever and i stop. Then i just feather it in and away i go.
The design is like i said very easy, yet affective. Its a common design, its sort of like a staton.inc design but instead made with metal square tubing. So here is what i did today, ill have it done by tomorrow so its only about 4-5 hours of work to get it complete. Quick huh!
http://www.youtube.com/watch?v=_5_TszprtYo
Well enjoy!
Regards,
Brendon.v
The design is like i said very easy, yet affective. Its a common design, its sort of like a staton.inc design but instead made with metal square tubing. So here is what i did today, ill have it done by tomorrow so its only about 4-5 hours of work to get it complete. Quick huh!
http://www.youtube.com/watch?v=_5_TszprtYo
Well enjoy!
Regards,
Brendon.v
but im getting the hinge and some springs tomoz so all i gotta do is fit them really and get some bolts n nuts to mount the engine n thats about it. I got exams this week so ill fit the stuff on the bike when im not studying but i should get it all done this week sometime. 
