Anyone running the Honda/Huasheng 49cc without the sheet metal air deflector on head?

I do not use the tin that would run across the exhaust port.
Reason is that I'd rather have cooler ambient air flowing over the exhaust valve area than the preheated forced engine air. These engine were designed for stationary use, hence the cooling fan and duct work. At 20+ mph, the cooling effect on the exhaust side of the engine is more efficient than the shrouded air.
Have you ever seen shrouding on a 4 stroke motorcycle engine?
I have over 630 miles on my 4 cycle and no burnt valves or loose exhaust seat, so I' guess I'm the proverbial "dumb newbie"
A more credible concern for those of you who have 4 strokes is to change the oil and adjust the valve
lash regularly.
Just my opinion....
 
I actually wondered if these might have been designed with a stationary engine probability in mind. I ride BMW air/oil cooled bikes....learned 15 years ago to start them and go immediately....no sitting and "warming up".....the exhaust pipes will actuall begin to glow like blacksmith's iron in a furnace if an oilhead BMW is left idling (noticeable at night).

Looking at the Huasheng, I notice that the shroud will have the effect of pushing the fan driven air FORWARD which in my mind, as the bike is moving forward,....air exiting the front of the engine will be doing battle with the air trying to move over the engine from front to back as the bike moves forward through that ambient air.

I think I will do some testing with my laser digital no-contact temp gun when I get it running. Head temps moving and sitting still with the shroud and then temps with the shroud/deflector off (not sitting still for long).

I think this is information we will all be interested to see. If I melt a cylinder barrel.....not the end of the world as the entire engine is what.......$150 (or less?) plus shipping??

I believe I will leave the shroud in place for the first couple of hundred miles....maybe 500 to have more consistent temps during break in.

Brian
 
I do not use the tin that would run across the exhaust port.
Reason is that I'd rather have cooler ambient air flowing over the exhaust valve area than the preheated forced engine air. These engine were designed for stationary use, hence the cooling fan and duct work. At 20+ mph, the cooling effect on the exhaust side of the engine is more efficient than the shrouded air.
Have you ever seen shrouding on a 4 stroke motorcycle engine?
I have over 630 miles on my 4 cycle and no burnt valves or loose exhaust seat, so I' guess I'm the proverbial "dumb newbie"
A more credible concern for those of you who have 4 strokes is to change the oil and adjust the valve
lash regularly.
Just my opinion....

I agree as to the piece under the exhaust and I do not use that either.
 
I Dont have a piece of sheet metal under the exhaust. The cylinder head is fully exposed on the front of the engine where the exhaust exits. Is this different from what you guys have?
 
Wildwest, We are talking about the same shroud piece.
I'd be curious to see your laser temp. readings.
Thanks.
 
It is. The engine also came with a piece that was held in place by the the muffler bolts on the front. that is what I gone.

The metal piece on the left curves around the back. That, as you noticed, is still there.
 
I actually wondered if these might have been designed with a stationary engine probability in mind.

Thats it right there, the GXH50 was designed as a stationary engine. On a vehicle with air flow you don't need the shrouds.
A header type exhaust with a remote muffler takes a lot of the heat away from the engine, the stock muffler holds heat near the head.
 
Back
Top