add a 90 degree grease( Gear Box Cover)

[MRJOHN]

add a 90 degree 1/4 grease fitting to your Gear Box Cover

 

[MRJOHN]

add a 90 degree 1/4 grease fitting to your Gear Box Cover

you may need to add a washer

 

[Al.Fisherman]

That was going to be my next mod, plus one in the engine valley for the clutch shaft (where the post for the clutch cable WAS)

 

[Rob_E_Rob]

Is this a good idea? Won't that saturate the clutch eventually?

 

[MRJOHN]

Is this a good idea? Won't that saturate the clutch eventually?

i have pics so you can see inside or by the clutch ,all you have to do is add a Washer or two

 

[mountain80]

Heck of a good idea, I have an machined adapter somewhat like this for my output shaft/bearings that simply screws into the cluch cable post thread for greasing then is removed till next time. If one was to add a MODERATE amount of grease while the engine is at idle I'm thinkin it would do a good job, could always shut down the engine and pull the cover and see the grease distribution as well getting an idea of how much of a portion of a stroke of a grease gun one needs.

 

[Dilly Bar Rob]

Great idea!

Will be my next mod.

Yeah I guess a guy would have to watch out not to over do it with the grease, just one quick pump with the gun should do.

Mind you, you still have to take the cover off occasionally to grease/lube the "ball race", so you get to see if your putting too much grease in there.

 

[Huntington]

very nice mod, I will be stealing this one too.