Wanted: GEBE Parts

Hi. I need used GEBE drive pulleys, drive ring and belt. The belt can be worn or broken; I'm just using it to measure for a shorter drive belt.

Using these for a DIY engine project.

BTW, does anyone know the inside diameter and outside diameter of the GEBE drive pulleys?:geek:
 
The inner diameter of the drive gear is 5/16 inch fine thread.

Thank you.

Can you measure the outside diameter of the edge of the drive pulley, and the outside diameter where the belt rides?

Which size pulley will you be measuring, ##11-12-13-14?
 
Last edited by a moderator:
13 tooth measurement

where the belt rides It looks like very close to 20 mm or a hair over 3/4 inch.
 
Woops. The outer diameter is 24 mm or about 15/16 inch. Oh, I'm using a cheap HF caliper so numbers aren't exact. Good luck.
 
Thanks again, pal.

What is the OD on the flange of this 13-t pulley?

Any idea on the pitch? That's the distance between each groove's centerline.

I've been reading up on belts and pulleys.:geek:

I'll probably need to call GEBE tomorrow.
 
Last edited by a moderator:
Back
Top