bobprobert
New Member
so i have the 2 stroke friction drive kit from daemon bikes. well i fired it up for the first time today and it started right up but then died after a few seconds. i noticed the roller wheel was no longer spinning freely so i took the motor off and the roller was unscrewed. i screwed it back in as tight as i could then put the motor back on. it rolled freely until i started it back up and went for a test drive. the first test ride went to the end of the street and back and no problems. then i went around the block and when i got back same problem. i have taken it back apart yet but im sure it's unscrewed again. any advice?