Neufcruz
Member
Clutch lever pulled in.
I went ahead and connected the clutch cable up. I used the left over steel braided sleeve and ran a new cable through so it matches the throttle cable.
My question is how far does the clutch arm need to pulled in?
I have the cable as tight as it can be without actually pulling it in. When I pull lever in, it only moves in about 1".
What's the proper way to set up?
I still need to pull off clutch cover and take a hammer as the drive sprocket does not spin at all even when clutch arm is pushed all the way in.
That's next!
Thanks in advance.
Mike