This project is taking a while (cash flow).
Slowly but surely . . .
- Thread starter Randall
- Start date
5-7HEAVEN
Well-Known Member
So the inner cone nut is what I need?
Picture attached . . .
Do you have ball bearings or sealed bearings on your rear axle?
Randall
Active Member
Sealed and just purchased some new ones as one bearing was bad.
5-7HEAVEN
Well-Known Member
I’m unable to get a good view on my phone of the axle you ordered.
But I don’t think you need cone nuts for your sealed bearings.
But I don’t think you need cone nuts for your sealed bearings.
Randall
Active Member
So just like you said just use washers that are small enough to hit just the race and not the body of the bearing. It just looked to me that the end of the cone nut would be small enough to do just that, but no worries, I will exchange the cone for washers. Its a longer axle that I needed anyway. I was using all thread and didn't like it.
5-7HEAVEN
Well-Known Member
Ok, my friend!
Good luck.
Good luck.
