i pulled the carb drain screw and it started then died

motoredjosh

Active Member
Local time
12:11 PM
Joined
Feb 12, 2022
Messages
127
fuel line not flowing right, i pulled the carb drain screw and it fired up momentarily then same thing as before, do i need to adjust my float?
 
i was thinking either i need to put a small vent hole in the gas cap or possibly just adjust the float anyone know appreciate it
 
i was thinking either i need to put a small vent hole in the gas cap or possibly just adjust the float anyone know appreciate it
Drain most of the fuel and take it for a ride with the cap loose and see if it stays running. If it does, then it's the cap.
 
Drain most of the fuel and take it for a ride with the cap loose and see if it stays running. If it does, then it's the cap.
ok it ran, which is progress, so its the gas cap, but now i have either a low bogg at low rpms? do you know what causes that?
 
I would also ask, where exactly do you have the C clip on the needle valve of the carburetor ???

If your running a stock NT or BoFeng carby that comes with the 2 stroke motor kits, it should be in the middle notch/groove of the needle valve at your altitude of 617 ft above sea level.

If that still proves to be too rich, then go upwards on the needle valve to the next to the top notch/groove to lean it out a little more if necessary...There should be 5 notches/grooves on your needle valve...DAMIEN
 

Attachments

  • Slide Needle Grooves.JPG
    Slide Needle Grooves.JPG
    5.8 KB · Views: 62
  • Slide Assembly.JPG
    Slide Assembly.JPG
    16.4 KB · Views: 62
Back
Top