Clutch won’t move at all

One of the most obvious reasons for this could be clutch shaft spring being too tight.
 
There are pics. And I got the clutch to work already I just need to order a couple more things and finish up the bike.
take the clutch cable support off and look into the hole. see where the clutch spring is.
 
Where does bearing place in this setup pertaining to the clucth arm
That round ball bearing is inside the housing, behind the bucking bar...Make sure the bearing has a dab of some white lithium or red and tacky grease and the bucking bar also has a dab or grease on both ends amd then slide that in the hole to rest up against the bearing...Take note that one end of that bar has a slight concave to it...the concave end is what rests against the ball bearing/throw out bearing...The bucking bar is the piece in contact with the clutch arm inside that cover/housing setup.
 
That round ball bearing is inside the housing, behind the bucking bar...Make sure the bearing has a dab of some white lithium or red and tacky grease and the bucking bar also has a dab or grease on both ends amd then slide that in the hole to rest up against the bearing...Take note that one end of that bar has a slight concave to it...the concave end is what rests against the ball bearing/throw out bearing...The bucking bar is the piece in contact with the clutch arm inside that cover/housing setup.
I got it that's what my problem was bearing wasn't in there I found it all nice and clean in hardware pack with spring for clutch cable
 
I got it that's what my problem was bearing wasn't in there I found it all nice and clean in hardware pack with spring for clutch cable
Now all ya got to do is go back to where I gave you clutch adjustment info and make sure everything is now working the way it should...lol.
 
I found it all nice and clean in hardware pack with spring for clutch cable
Ya...Contrary to popular belief, they are not spare, unnecessary, parts in those little baggies...lol...lol.

The Chinese manufacturers are already only providing the bare minimum parts needed to begin with...lol...Lets not give them any more ideas what we can do without and what they can save even more money on by not providing in these kits...lol...lol.
 
Can you put the cover with the clutch arm on the engine? Pull the bucking bar out and check to see if you have two balls in there instead of one. You might have to squirt some PB or WD in the hole to get the ball/s out.

Ya...Contrary to popular belief, they are not spare, unnecessary, parts in those little baggies...lol...lol.

The Chinese manufacturers are already only providing the bare minimum parts needed to begin with...lol...Lets not give them any more ideas what we can do without and what they can save even more money on by not providing in these kits...lol...lol.
I know that right I didn't see it in there first go around because it was in nut bolts bag not bag with spring and lever , cable like you would think.
 
Back
Top