Wevil Knievel
Active Member
- Local time
- 12:37 PM
- Joined
- Apr 5, 2021
- Messages
- 208
I recently scored a 1 1/8 in neck tube Triple Tree set of forks and unfortunately the neck tube was 1 in and the steer tube was 1 1/8.
To make a 1 1/8 in fork steer tube fit into a 1 inch neck tube all you have to do is take a 1 1/8 inch neck tube cut it in half sand it out a little bit pound it down onto the existing 1 inch neck tube and put your cups back on. No welding required.
Its not as hard as it sounds. See my photos.
It works like a charm.( I will post pictures tomorrow morning when it is daylight outside.)
To make a 1 1/8 in fork steer tube fit into a 1 inch neck tube all you have to do is take a 1 1/8 inch neck tube cut it in half sand it out a little bit pound it down onto the existing 1 inch neck tube and put your cups back on. No welding required.
Its not as hard as it sounds. See my photos.
It works like a charm.( I will post pictures tomorrow morning when it is daylight outside.)