06...I didn't have the proper size metric wrench and used a 7'8" wrench. Place wrench on the puller nut and let the wrench rest between the clutch pla
03
04...Screw the small male end into the gear, making sure that the inner bolt does not bottom out at this time.
05...Screw down the gear puller until tight. You will need to jam both gears. If the cylinder is off a block of wood below the piston will work, or if
06...I didn't have the proper size metric wrench and used a 7'8" wrench. Place wrench on the puller nut and let the wrench rest between the clutch pla
07...Using a 14mm box wrench or socket tighten down on center bolt of removal tool. This is on tight so some effort will be needed. If you get to the
Al.Fisherman

06...I didn't have the proper size metric wrench and used a 7'8" wrench. Place wrench on the puller nut and let the wrench rest between the clutch pla

There are no comments to display.

Media information

Album
Small clutch gear removal.
Added by
Al.Fisherman
Date added
View count
537
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top