1st drilled 2 1/8" holes, then "wallered" them larger w / a 3/8" bit. And don't forget the RED locktite on these!
Sets the motor just right. (FYI, you will need to heat & bend the exaust pipe a little to clear the cranks.)
Bottom view. (Brackets came with all the hardware & bolts. Also came with rear wheel adjusters that fit into the dropouts. Kinda like the ones you see
Rear view.
1st drilled 2 1/8" holes, then "wallered" them larger w / a 3/8" bit. And don't forget the RED locktite on these!
Passenger side view of Barry W.'s awesome motor bracket settup. Well designed & made. They shipped fast & came with good directions too.
Matching Schwinn wired speedometer. (Haven't found a wireless one yet that will work with a motor.)
A different angle.
coax1ogsking

1st drilled 2 1/8" holes, then "wallered" them larger w / a 3/8" bit. And don't forget the RED locktite on these!

There are no comments to display.

Media information

Album
Schwinn OCC Chopper, 66cc ZM Motor, (client brought to me) *Thanks Dad & Barry for the brackets!
Added by
coax1ogsking
Date added
View count
674
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top