b1 Old School Bending Technique

b1 Old School Bending Technique
RusticoRay, May 17, 2009
    • insomniacshotrods
      I just started a build with a frame like that because the rear was as wide as it was lol..I bought the shifter kit from sick bike parts and a nuvinci rear hub and was almost done with the bike till i went to mock up the hub and found the frame was about 4 inches too narrow. OH well thats the way build go. looking good so far.
    • RusticoRay
      Hey how much room did you need ? In one of the photos the chain and top stays where spread out wide. I didnt measure it I just put the strap on it to bring it back, I was afraid it was going to break a weld somewhere. Im copying the measurements from my whizzer to get enough room for a 2.125 wheel and belt sheave.
    There are no comments to display.
  • Album:
    Schwinn Typhoon
    Uploaded By:
    May 17, 2009
    View Count:
    Comment Count: