Photo 8 of 59 Finish removing the cylinder jug and set aside. Don't be of concern if the gasket tears up at this time. When putting back together we w
Photo 5 of 59 Remove these two 6mm bolts. These are 2 of 8 that hold the case together.
Photo 6 of 59 After the head is removed pull cylinder jug up to expose the piston.
Photo 7 of 59 Here you can see the set (2) rings on the piston.
Photo 8 of 59 Finish removing the cylinder jug and set aside. Don't be of concern if the gasket tears up at this time. When putting back together we w
09 Pin keeper
10 Remove wirst pin keeper
11 Side with keeper
Al.Fisherman

Photo 8 of 59 Finish removing the cylinder jug and set aside. Don't be of concern if the gasket tears up at this time. When putting back together we w

B
ok thanks. Also when im putting it back together i cant seem to get the piston back through the cylinder sleve, the piston rings are impeding it from going in how can i fix that.
 
M
OK you coat both the cylinder and the case's with the gasket maker do you let it set up before you install or install and tighten til it starts to ooze and then let it cure and then tighten the rest of the way?
 

Media information

Album
Teardown Chinese HT 49/80cc engine.
Added by
Al.Fisherman
Date added
View count
2,581
Comment count
4
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top