Even the tank mount was at the maximum of the supplied mount hardwares limits. Just barely got the nuts on and believe one may have stripped. I have a
Accelerator and rear brake orientation.
Control orientation for clutch, front brake, and pedal deraileur. Seemed logical as I hope to be powered more than pedal if all goes well. You can see
The dremmel work on the front mount to just get the carb to clear the top of the frame and Ill need to go a little further yet.
Even the tank mount was at the maximum of the supplied mount hardwares limits. Just barely got the nuts on and believe one may have stripped. I have a
This gives an indication of the thickness of the down tube from the handle bars. Its creating some challenges to say the least.
Its hard to see but the exhaust is tight against the front tube and still will not meet the motor completely flush, guess some heating and bending wil
I plan on using a dremmel to put a slight concave area on this section just to keep it centered and this should allow the engine to drop just a slight
Lunardog

Even the tank mount was at the maximum of the supplied mount hardwares limits. Just barely got the nuts on and believe one may have stripped. I have a

There are no comments to display.

Media information

Album
My first build
Added by
Lunardog
Date added
View count
425
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top