I was able to use the supplied adapter plate and u-bolt that came with the kit for the Rear Motor Mount. I wrapped around the bicycle frame with elec
Slide Push Rod into Rear Axle and tighten Shimano Bell Shifter onto Axle. Put Bicycle in 2nd Gear and adjust nut on cable to put yellow dot centered
Instead of drilling more holes in the frame of the Cargo-T, I went with making an adapter plate to mount the Front and using the supplied plate to mou
Rear Motor Mount using supplied adapter plate, u-bolt and spacer in kit.
I was able to use the supplied adapter plate and u-bolt that came with the kit for the Rear Motor Mount. I wrapped around the bicycle frame with elec
I made a similar adapter plate from 1/4" Steel Bar and a 2" U-bolt for the Front Motor Mount
DSC08670
DSC08671
D

I was able to use the supplied adapter plate and u-bolt that came with the kit for the Rear Motor Mount. I wrapped around the bicycle frame with elec

There are no comments to display.

Media information

Album
Torker Cargo -T Flying Horse 2-Cycle Installation
Added by
dinoseer
Date added
View count
386
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top