B
Blue Coupe
Guest
I started to install my Golden eagle 25cc Mini 4 on my Aluminum frame bike and ran into a few issues.
The small frame tubes that angle down from the seat post to the axle will not allow the engine mount to be attached straight up and down. I could angle the engine mount back, however I would rather not since the engine would be significantly over the back of the tire.
Even if I could clear the frame tubes, the axle is bolt is too short. Does anyone make longer axles for a Shimano FR RM40 hubs? The other concern is that the axle bolt is tiny in diameter.
Also, the derailer is attached to the frame with small screws that will interfere with the engine mounts. I intend to shorten the screws and mount them from the inside of the frame, it might work.
Attached are a few photos.
Suggestions?
Thanks
The small frame tubes that angle down from the seat post to the axle will not allow the engine mount to be attached straight up and down. I could angle the engine mount back, however I would rather not since the engine would be significantly over the back of the tire.
Even if I could clear the frame tubes, the axle is bolt is too short. Does anyone make longer axles for a Shimano FR RM40 hubs? The other concern is that the axle bolt is tiny in diameter.
Also, the derailer is attached to the frame with small screws that will interfere with the engine mounts. I intend to shorten the screws and mount them from the inside of the frame, it might work.
Attached are a few photos.
Suggestions?
Thanks
Attachments
Last edited by a moderator: